 |
|
| PLUMBING |
|
Soldering tip for Your Heating System
When replacing sections of baseboard heating units, use small white bread plugs at each end of the removed sections. Be sure there is no crust on the bread. After shutting down and draining your heating system, clean, flux and assemble the replaced section, and solder the copper fittings. The plugs will keep the water away from the joints and maintain temperature while soldering. The recirculating water will dissolve the bread plugs and return circulation to the system.
Return to Previous Search Results
|
|
|
Brought to you by...
|
|
|
Did you know...
|
 |
WD-40 cleans grease and gum off car floor mats |
The trade secrets described in the WD-40 Job Site were provided to WD-40 Company by industry professionals, and do not constitute recommendations or suggestions from WD-40 Company. WD-40 Company has not tested these tips. Consumers should exercise caution when attempting to complete a project, and take heed of any warnings printed on the WD-40 packaging.
In consideration of my acceptance and enjoyment of the WD-40 Job Site, I hereby release and hold harmless, on behalf of myself, my executors, administrators and my heirs, WD-40 Company and its employees, officers and agents from any liability or claim for damages arising out of my acceptance and/or enjoyment of the WD-40 Job Site, including, but not limited to, personal injury, theft, assault, or death.
|
|
|
|
